Filter
Top Products
User's Guide 21
Loading Media
1. Open the Media Access Cover by lifting it up until it rests in the vertical position.
2. Slide the two Print Head Latches toward the back and unlock the print head module.
3. Raise the print head module.
Figure 11 – Open Media Access Cover
4. Insert the Media Spindle into the core of the label media. The Retainer Disk should be
on the right of the media with the smooth side toward the media.
Figure 12 – Media Spindle and Retainer Disk
5. Insert the Media Spindle and media assembly into the spindle holder slots inside the
printer. The labels should be face out feeding off the top of the roll.
6. Slide the media to the far left and then slide the Retainer Disk up against the media until
it is snug.
7. In the base of the printer locate the Right and Left Media Guides.
Media Spindle
Retainer Disk
Print Head Latch
Print Head Latch
Media Access Cover