Filter
Top Products
7200
TROUBLESHOOTING
4-15
Operation Manual
Error Message Error State Recovery Procedure
SYSTEM ERROR:
PRINT POSITION
An error has occurred during the print head
positioning.
Contact a service technician.
SYSTEM ERROR:
FUSE
A fault was detected in the fuse.
SYSTEM ERROR:
SERVOMOTOR
The servo motor is overloaded.
COM.ERROR:
PARITY
The RS232C interface has an error.
(An error was detected in the
communication parity.)
COM.ERROR:
PROTOCOL = **
The RS232C interface has an error.
An error was detected in the communication
protocol. (Ex. STX, ETX, LRC, time-out,
etc.)
COM.ERROR:
FRAME
The RS232C interface has an error.
An error was detected in the communication
framing.
COM.ERROR:
OVER RUN
The RS232C interface has an error.
Communication overrun error
COM.ERROR:
BLOCK TOO LONG
The RS232C interface has an error.
Too-long block was received.
MAGNETIC ERROR:
XXX XXX XXX XXX
A magnetic error was detected in the track,
block, etc.
SYSTEM ERROR:
PARAMETER FAULT
The incorrect setup parameter was
specified.
SYSTEM ERROR:
EXP.ROM FAULT
An error was detected in the extension
memory.
SYSTEM ERROR:
PECTAB FAULT
A fault was detected in PECTAB.
SYSTEM ERROR:
BATTERY LOW
The voltage of the backup battery is low.
SYSTEM ERROR:
MCU ERRCODE = **
System error
SYSTEM ERROR:
SCU ERRCODE = **
System error
SCN ERROR:
MAG.NOT FOUND
Non-existent error
SCN ERROR:
NOT READABLE
SCN reading errors occurred twice
successively.
SCN ERROR:
NOT FOUND
When a command for asking SCN was
received, SCN reading error occurred.
SCN ERROR:
BIN NOT FOUND
Setting error for SCN
SCN READING ERR
REMOVE VOID DOC.
SCN reading error