Filter
Top Products
User Manual version 2007
APOLLO 120/150 III
5-
59
HDD
HDD ²Õ«~
HDD CABLE 220mm
HDD ¬[
FIGURE 5-4: HDD INSTALLATION
5.6. HDD Module Assembly
The APOLLO provides enough space to build in a 3.5” hard
disk drive in the system compartment. The following steps
show the way to install an internal hard disk drive.
1. Make the chassis lower side near you. Now, from your
point of view, the 3.5" HDD module is to be installed to the
right upper side of the system compartment.
2. Refer to Figure 5-4. Fix the hard disk drive (1) to the HDD
bracket (3) with 2 flat-head screws.
3. Connect the one end of the 40-pin IDE cable (2) to hard
disk drive.
4. There are two clips at the bottom of the compartment used
to hold the HDD module to the system compartment.
Insert the HDD module to the compartment and clip it into
place. Fix the HDD module to the chassis with one 3*5
flat-head screw outside of the right upper side of the
chassis.
5. Make sure the other end of the 40 pin IDE cable is
connected to the motherboard IDE 1 connector.