Filter
Top Products
Basics Memory Configurations - 9
Memory Configurations
The Power Macintosh 7200 and WS 7250 logic boards have
four DRAM DIMM slots, each with a 64-bit data bus. You can
increase the computer’s DRAM to a total of 256 MB using 5-
volt, 64-bit-wide, 168-pin fast-paged mode, 70 ns
DIMMs.
Note:
These computers do not have any main memory
soldered to the logic board. At least one DRAM DIMM must be
present for the computer to operate.
DRAM DIMMs can be installed individually or in pairs. These
computers support linear memory only; therefore, no
memory gains are seen when two DIMMs of the same size are
installed (that is, memory interleaving is not supported on
the Power Macintosh 7200 Series/WS 7250 computers).