Filter
Top Products
Troubleshooting Symptom Charts/Floppy Drive - 17
Disk does not eject 1 Verify the floppy disk is inserted squarely in the drive. Push
the disk in from the center edge.
2 Try floppy drive in opposite expansion bay.
3 If floppy drive is in the right expansion bay, switch off
system and hold down command shift 1 while you restart.
4 If floppy drive is in the left expansion bay, switch off system
and hold down command shift 2 while you restart.
5 Eject disk manually by carefully inserting opened paper clip
into hole near floppy drive slot.
6 Replace floppy drive.
7 Replace I/O logic board.