Filter
Top Products
HARDWARE INSTALLATION
39
Warning:
High voltages may be found inside computer equipment. Be-
fore installing any of the hardware in this package or remov-
ing the protective covers of any computer equipment, turn
off power switches and disconnect power cords. Do not re-
connect the power cords until you have replaced the covers.
electricity.
2.3 Installation
Follow the instructions below to install a SATA RAID controller into
your PC / Server.
Step 1. Unpack
Unpack and remove the SATA RAID controller from the package.
Inspect it carefully, if anything is missing or damaged, contact your
local dealer.
Step 2. Power PC/Server Off
Turn off computer and remove the AC power cord. Remove the
system’s cover. See the computer system documentation for in-
struction.
Electrostatic Discharge
Static electricity can cause serious damage to the electronic com-
ponents on this SATA RAID controller. To avoid damage caused by
electrostatic discharge, observe the following precautions:
• Don’t remove the SATA RAID controller from its anti-static pack-
aging until you are ready to install it into a computer case.
• Handle the SATA RAID Controller by its edges or by the metal
mounting brackets at its each end.
• Before you handle the SATA RAID controller in any way, touch a
grounded, anti-static surface, such as an unpainted portion of the
system chassis, for a few seconds to discharge any built-up static