Filter
Top Products
IPS 1000 Series VoIP Gateway
15
5. Dial “9507#”；Assuming you are modifying for China (The last 2 digits are the regional ID)
6. Dial “971
#” ；Sets the new regional ID.
7. Hang up the phone. The device will be updated with the new region setting after it restarts (restart
time is about 10 seconds)
9.1.2. System console settings (Only for 4/8/16 ports)
SIP-RG>enable
SIP-RG #configure
Enter configuration commands, one per line. End with CNTL/Z
SIP-RG(config)#regional_id 07
SIP-RG(config)#exit
SIP-RG#delete nvram
This command resets the system with factory defaults.
All system parameters will revert to their default factory settings. All static
and dynamic addresses will be removed.
Reset system with factory defaults, [Y]es or [N]o? Yes
Attention:
Before Changing the Region ID, the system has to be reset to the default value. Therefore this step
should be done first.
The following instruction may keep the IP address unchanged after reset:
“delete nvram keep_ip”
9.2. IP Address Settings
We recommend using a traditional phone to configure the unit’s parameters, as this is the easiest way.
The following two sections contain the procedures used to configure the IPS unit according to how you
obtain your IP address (Static IP; DHCP or PPPoE).
Attention:
Every time you set a parameter item and press the “#” key to complete it, a successful setting will be
confirmed by three equal tones in succession. If your setting is unsuccessful you will be prompted with
one long tone.