Filter
Top Products
4-164-16
4-164-16
4-16
Chapter 4: BIOS setupChapter 4: BIOS setup
Chapter 4: BIOS setupChapter 4: BIOS setup
Chapter 4: BIOS setup
Enhanced Mode Support On [S-ATA]
The default setting S-ATA allows you to use native OS on Serial ATA
and Parallel ATA ports. We recommend that you do not change the
default setting for better OS compatibility. In this setting, you may
use legacy OS on the Parallel ATA ports
only ifonly if
only ifonly if
only if you did not install any
Serial ATA device.
The P-ATA+S-ATA and P-ATA options are for advanced users only. If
you set to any of these options and encounter problems, revert to the
default setting
S-ATAS-ATA
S-ATAS-ATA
S-ATA. Configuration options: [P-ATA+S-ATA]
[S-ATA] [P-ATA]
IDE Detect Time Out [35]IDE Detect Time Out [35]
IDE Detect Time Out [35]IDE Detect Time Out [35]
IDE Detect Time Out [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
Onboard Serial-ATA BOOTROOM [Enabled]
Enables or disables the onboard Serial ATA boot ROM. This item
appears only when the Configure SATA As item is set as RAID.
Configuration options: [Disabled] [Enabled]
The
Onboard IDE Operate ModeOnboard IDE Operate Mode
Onboard IDE Operate ModeOnboard IDE Operate Mode
Onboard IDE Operate Mode and its submenu items appear only
when the
Configure SATA AsConfigure SATA As
Configure SATA AsConfigure SATA As
Configure SATA As item is set to Standard IDE.
ALPE and ASP [Disabled]ALPE and ASP [Disabled]
ALPE and ASP [Disabled]ALPE and ASP [Disabled]
ALPE and ASP [Disabled]
Enables or disables the ALPE and ASP. This item appears only when the
Configure SATA As item is set as AHCI.
Configuration options: [Disabled] [Enabled]
Stagger Spinup Support [Enabled]
Enables or disables the stagger spinup support.
Configuration options: [Disabled] [Enabled]
AHCI Port 3 Interlock Switch [Disabled]
Enables or disables the Advanced Host Controller Interface (AHCI) Port
3 interlock switch. Configuration options: [Disabled] [Enabled]
The
Onboard Serial-ATA BOOTROMOnboard Serial-ATA BOOTROM
Onboard Serial-ATA BOOTROMOnboard Serial-ATA BOOTROM
Onboard Serial-ATA BOOTROM item appears only when the
Configure SATA AsConfigure SATA As
Configure SATA AsConfigure SATA As
Configure SATA As item is set to RAID.
The
ALPE and ASPALPE and ASP
ALPE and ASPALPE and ASP
ALPE and ASP item appears only when the
Configure SATAConfigure SATA
Configure SATAConfigure SATA
Configure SATA
AsAs
AsAs
As item is set to AHCI or RAID.