Filter
Top Products
ASUS P5ND2-SLI SeriesASUS P5ND2-SLI Series
ASUS P5ND2-SLI SeriesASUS P5ND2-SLI Series
ASUS P5ND2-SLI Series
2-292-29
2-292-29
2-29
5.5.
5.5.
5.
Silicon Image Serial ATA RAID connectorSilicon Image Serial ATA RAID connector
Silicon Image Serial ATA RAID connectorSilicon Image Serial ATA RAID connector
Silicon Image Serial ATA RAID connector
(7-pin SATA_RAID2) (7-pin SATA_RAID2)
(7-pin SATA_RAID2) (7-pin SATA_RAID2)
(7-pin SATA_RAID2) (
Deluxe model only
)
This connector is for a Serial ATA signal cable. It supports a Serial ATA
hard disk drive that you can combine with an external Serial ATA
3Gb/s device to configure a RAID 0 or RAID 1 set through the
onboard Silicon Image SATA RAID controller. Refer to Chapter 5 for
details on how to set up Serial ATA RAID configurations.
See section “4.4.8 Onboard Devices Configuration” on page 4-32 for
details.
• Before creating a RAID set using Serial ATA hard disks, make sure
that you have connected the Serial ATA signal cable and installed
Serial ATA hard disk drives; otherwise, you cannot enter the Silicon
Image RAID utility and SATA BIOS setup during POST.
• Use this connector and an external Serial ATA box connected to the
external SATA port, if you want to configure a RAID 0 or RAID 1 set.
• The Serial ATA port multiplier and external Serial ATA box are
purchased separately.
DO NOT unplug the external Serial ATA box when a RAID 0 or RAID 1 was
configured.
P5ND2-SLI
®
P5ND2-SLI Series SATA RAID connector
SATA_RAID2
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND