Filter
Top Products
Powering Off and Restarting
If it becomes necessary to Power Off one of the ACS-1208A / ACS-
1216A units, unplug the power adapter cable from the rear panel.
Before starting it back up you must do the following:
1. Shut down all the computers that are attached to it.
Note: You must unplug the power cords of any computers that
have the Keyboard Power On function. Otherwise, the
switch will still receive power from the computers.
2. Wait 10 seconds, then plug the Station back in.
3. After the Station is up, Power On the computers.
Note: If you have shut down more than one Station, power up the
highest Station first and work your way down to the lowest one.
Port Selection
Port Selection is accomplished either by entering Hotkey combinations
from the keyboard, or by means of the ACS-1208AL / ACS-1216AL’s
OSD (On Screen Display). Hotkey Port Selection is discussed in the next
chapter; OSD Operation is discussed in detail in Chapter 4.
2003-01-27
Installation
2-7