Filter
Top Products
Auto Scanning Auto Scan automatically switches among all the active CPU Ports that are
accessible to the currently logged on User at regular intervals, so that he
can monitor their activity automatically. (See Scan/Skip Mode of the OSD
F3 SET function, p. 4-7 for information regarding accessible ports.)
Setting the Scan Interval:
The amount of time Auto Scan dwells on each port is set with the Scan
Duration setting of the OSD F3 SET function (see p. 4-7). You can
change the scan interval before activating Hotkey Auto Scanning, if you
wish, with the following Hotkey combination:
1. Invoke Hotkey Mode (see p. 3-1).
2. Key in [T] [n]
Where [T] is the letter T, and [n] is a number from 1-255 that
represents the number of seconds the system dwells on a port
before going on to the next.
The letter T and the numbers display on the Command Line as
you key them in. If you make a mistake, use [Backspace] to erase
the wrong number.
3. Press [Enter]
After you press [Enter], you automatically exit Hotkey Mode, and
are ready to invoke Auto Scanning.
2003-01-27
Hotkey Operation
3-3