Filter
Top Products
77
2
1
3
4
5
6
7
8
9
10
section
Manually Configuring Network Settings
Manually Configuring Network Adapters in Windows 98SE or Me
1.
Right-click on “My Network Neighborhood” and select “Properties”
from the drop-down menu.
2. Select “TCP/IP -> settings” for your installed network adapter. You will
see the following window.
(1)
(2)
(3)
3. If “Specify an IP address” is selected, your Router will need to be set
up for a static IP connection type. Write the address information in the
table below. You will need to enter this information into the Router.
4. Write in the IP address and subnet mask from the “IP
Address” tab (3).
5. Click the “Gateway” tab (2). Write the gateway address down
in the chart.
6. Click the “DNS Configuration” tab (1). Write the DNS address(es)
in the chart.
7. If not already selected, select “Obtain IP address automatically” in the
“IP Address” tab. Click “OK”.
Restart the computer. When the computer restarts, your network
adapter(s) are now configured for use with the Router.