Filter
Top Products
2-4 Operator’s Handbook
6. Remove the clear wrap from a new ribbon and tear it at the perforation.
7. Make sure the preprinted side of the ribbon faces out. Slide the ribbon reel onto the long
spool with the foam washer and the take-up reel onto the short spool. Thread the ribbon
around the ribbon guide. Turn the ribbon roll slightly to take up some of the excess slack, if
necessary.
Do not wind the ribbon too tightly. Do not touch the ribbon with your fingers. Do not wrinkle
or twist the ribbon.
Note: If you are using a 2-inch or 3-inch ribbon, push the core of the ribbon roll onto the spool
of the cassette but do not force it or you may damage the foam washer. Do not touch
the ribbon with your fingers!
Gear
Latches
New Ribbon
A
B
Take-up Core
Foam Washer
A
Ribbon
Guide