Filter
Top Products
4-2 Operator’s Handbook
Error Description
613
Invalid Data
Reference point off supply.
614
Invalid Data
Portion of field off supply or there may be an invalid character in the packet.
703
Check Supply
The printer sensed a calibration of different-sized black marks. Make sure the
correct supply is loaded.
704
Check Supply
Printer has not sensed a supply mark within the specified number of inches or is
out of supplies. Check the supply tracking, supply marks, black mark sensor
position, and supply roll for binding. Press X to clear the error.
Change supply.
750
Hot Head
Printhead is overheated. Press X to clear the error.
Turn off the printer to let the printhead cool. If error persists, call Service.
751
Check Supply
Printer did not sense a black mark when expected.
For errors 751-753, Check the supply tracking, supply marks, black mark sensor
position, and supply roll for binding. Press X to clear the error and try to
continue printing the batch. Change supply.
752
Check Supply
Printer sensed a mark in the wrong place. Press X to clear the error.
753
Check Supply
Printer sensed a mark that is too long. Press X to clear the error.
756
Load Supplies
Load supplies. Press X to clear the error.
757
Load Supplies
Load supplies (supply length mismatch), because the calibrated supply length
differs by plus or minus 0.25 inches from the format. Press X to clear the error.
758
Check Supply
Either the supply is not seen or the on-demand sensor is broken. Press X to
clear the error. Check for a label jam, clear the supply path, or reload supplies.
This error may occur if you remove a label too quickly in on-demand mode. The
printer does not recalibrate after this error.
762
Low Battery
Recharge the battery. Press X to clear the error.
763
Remove Label
Waiting to dispense label. Press X to clear the error.
765
Check Printhead
The printhead has less than four bad dots. The printer can shift bar code fields
to avoid bad dots. Press X to clear the error and continue printing.
768
Check Printhead
Printhead has more than 10 bad dots or is not connected. Connect the
printhead. Press X to clear the error.
791
Error Pending
The printer has an error pending. Turn off the printer.
Wait 15 seconds and turn it back on. Resend the packets.
Calling Technical Support
If these solutions do not work, or you see an error that is not listed here, call Service at the
number listed on the back of this manual.
If you need to return the printer, use the original packaging (box and packing material).