Filter
Top Products
2-6 Operator’s Handbook
4. Pull out the supply so that a few inches extend past the front of the printer. Center the
supply across the platen roller.
5. Raise the supply door back to the upright position but do not close the printer.
6. Remove a couple of labels from the liner. Feed the liner over the platen roller, over the peel
bar, and under the peel edge as shown. Center the supply under the peel edge.
7. Close the printer completely. See “Opening & Closing the Printer” for more information.
8. Lightly tug on the liner to remove the slack.
9. Turn on the printer if it is not already on.
10. Press
under once or twice to advance the labels under the printhead. If you receive a
supply error, see Chapter 4, "Troubleshooting.”
The label separates from the liner.
Loading for fan-fold
Use these instructions for fan-fold supplies only.
1. Open the printer. See “Opening & Closing the Printer” for more information.
2. Adjust the 4.8-inch (122 mm) core to the width of your fan-fold supplies by
pushing or pulling the supply guides on each side of the core.
The guides move in 0.03-inch (0.8 mm) increments.
Note: Make sure the guides are straight after you
adjust them.
3. Insert the core between the supply holder tabs to open them to their
widest position.
Liner
Peel Bar
Peel Edge