Filter
Top Products
3-3
Location and Functions of Control
5976069 BARCOREALITY 6400 21082000
F1
F2
F3
F4
F5
ADJ
EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS
VOL
9
0
78
5
6
34
1
2
1
2
3
5
6
4
7
8
9
10
18
17
16
15
14
13
12
11
COLOR
PHASE
SHARPN
TINT
BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
2
1
4
3
5
6
8
0
9
7
CONTRAST
9
12
11
14
5
15
17
16
6
b. Remote control
This remote control includes a battery powered infrared (IR)
transmitter that allows the user to control the projector remotely.
This remote control is used for source selection, control,
adaptation and set up. It includes automatic storing of :
- picture controls (Brightness, Sharpness...)
- settings
Other functions of the remote control are :
- switching between standby and operational mode.
- switching to "pause" (blanked picture, full power for
immediate restarting)
- direct access to all connected sources.
Remote Control (RCU)
Local keypad
Terminology
1 Function keys : user programmable keys with functions for direct access.
2 ADJ. : to escape the adjustment mode.
3Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed address key with
a pencil, followed by pressing one digit button between 0 and 9.
4 Selection key : to direct access the zoom/focus/shift functions.
5 PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for immediate restarting.
6 STBY : stand-by button, to start projector when the power switch is switched on and to switch off the projector without switching
off the power switch.
Attention : Switching to Stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key for 2 seconds until the message 'Saving
data, please wait' is displayed. Do not press any longer on the stand-by key otherwise the projector will restart.
7 Mute : to interrupt the sound reproduction.
8? : Auto image, to center the image on the active LCD surface.
9 Digit buttons : direct input selection.
10 Audio controls : use these buttons to obtain the desired sound level (see also 'Controlling').
11 Picture controls : use these buttons to obtain the desired picture analog level (see also 'Controlling').
12 PHASE : used to remove the instability of the image.