Filter
Top Products
Service Mode
11-5
5976069 BARCOREALITY 6400 21082000
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
BARCO LOGO
PANEL ADJUSTMENTS
UNIFORMITY
PRESET INPUT BALANCE
I2C DIAGNOSIS
MORE...
BARCO LOGO
STATUS : [ON]
BACKGROUND : [ON]
SHIFT
HOT KEY : [TEXT]
Select with or
then <ENTER>
<EXIT> to return.
Dimming
The lamp can be dimmed. Therefore:
1 Push the cursor key é or ê to highlight 'Lamp Dimming'.
2 Press ENTER to select.
3 Push the cursor key ç or è to dim the lamp.
Remark : The projector starts always with full lamp power.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
DIMMING
MORE...
SERVICE
BARCO LOGO
PANEL ADJUSTMENTS
UNIFORMITY
PRESET INPUT BALANCE
I2C DIAGNOSIS
MORE...
WARNING
PANEL ADJUSTMENTS
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return.
BARCO logo
The BARCO logo can be added to the image, in overlay or on a
background, on any place on the screen.
To add the BARCO logo or to change a setting in the BARCO logo
menu:
1 Push the cursor key é or ê to highlight 'BARCO logo''.
2 Press ENTER to display the BARCO logo menu. The actual
settings will be displayed.
Within this menu, three toggle settings and a shift control are
available.
STATUS [ON/OFF]
ON : BARCO logo will be displayed on the screen.
OFF : No BARCO logo displayed on the screen.
BACKGROUND [ON/OFF]
ON : BARCO logo will be displayed on a black background.
OFF : BARCO logo will be displayed without any background.
SHIFT
By pushing the cursor key é, ê, ç or è, the BARCO logo can
be positioned anywhere on the screen.
HOT KEY [TEXT/OFF]
OFF : no key on the RCU is used to display the BARCO logo.
TEXT : the TEXT key on the RCU is used to display or to remove the
BARCO logo with one single push on this key (only in operational
mode).
Panel Adjustments
Changing these settings may seriously affect the perform-
ance of the projector.
All panel adjustments are factory adjusted. If not really necessary,
do not touch any of these adjustments. They are useful when a new
panel is installed.
When Panel Adjustments is selected in the Service Mode selection
menu, the following warning will be displayed :
Panel Adjustments is reserved to qualified service personnel.
If you are not qualified, press EXIT to cancel the panel adjustments.