Filter
Top Products
Service Mode
11-4 5976069 BARCOREALITY 6400 21082000
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
Change Baudrate PC
The communication speed between projector and computer, e.g. PC
or MAC, has 8 possible speeds. The baud rate speed can be
software set. Handle as follow:
1 Push the cursor key é or ê to highlight 'Change Baudrate
PC''.
2 Press ENTER to display the Change Baudrate PC menu. The
actual baudrate will be highlighed.
The following baud rates are available :
230400/115200/57600/38400/19200/9600/4800/1200
3 Push the cursor key é or ê to highlight the desired baudrate.
4 Press ENTER to select.
Reset Lamp Runtime
Reset lamp run time is only allowed when a new lamp is installed.
When Reset Lamp Run Time is selected in the Service Mode selection
menu, the following warning will be displayed :
Risk of electrical shock. Reset lamp run time is reserved to qualified
service personnel.
If you are not qualified, press EXIT to cancel the reset operation.
Lamp Run Time History
To get an overview of the different lamp run times:
1 Push the cursor key é or ê to highlight 'Lamp Run Time
History'.
2 Press ENTER to display the Lamp Run Time overview.
A listing with the lamp serial number and the corresponding
run time will be displayed.
The actual installed lamp will be marked.
3 Press EXIT to return to the service mode selection menu.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
DIMMING
COMMON ADDRESS : 0
MORE...
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
DIMMING
COMMON ADDRESS : 0
MORE...
LAMP RUNTIME HISTORY
Serial No Runtime
-----------------------------------------------------
> 0111121 600 h
0110031 980 h
0110010 1000 h
0000000 0 h
0000000 0 h
0000000 0 h
-----------------------------------------------------
<ENTER> for detail
<EXIT> to return
WARNING
-----------------------------------------------------
RISK OF
ELECTRICAL SHOCK
______________________________________________________________
RESET LAMP RUN TIME
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return.
Common Address
Every projector listens to a common address. This common address
can be set to '0' or '1'. When the RCU is programmed with that common
address, every projector with that same common address will follow
up the commands given by that RCU.
To change the common address :
1 Push the cursor key é or ê to highlight 'Common Address'.
2 Press ENTER to toggle between '0' and '1'.
CHANGE PROJ. ADDRESS
Projector address 001
Common address 0
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return