Filter
Top Products
Connections
3-1
5975597 BARCODATA 808S 110397
3
CONNECTIONS
PORT 4/5
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
75 Ohm
PORT 2
75 Ohm
This device comp lies wit h part 1 5 of
th e FCC ru les. Op erati on is su bj ect to
following two condi tions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any in terference received
including interference that may cause
undesired operation"
120/230 V
7/5 A mp
50/60 Hz
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector to
the wall outlet. Plug the female power connector into the
male connector at the backside of the projector.
Power Check
The power voltage is determined by the art. no., listed on sticker on
the back side of the projector.
Warning !
Verify the power voltage corresponds to that of the wall outlet.
Art. No. R9002031 must be connected to a 230 VAC power source.
Art. No. R9002038 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Switching On/Off
The projector is switched ON and OFF using the power (mains) switch
ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start in the 'operational mode' (image displayed) or
in the 'stand by mode', depending on the position of the 'power up' dip
switch on the controller unit. This DIP switch must be set during
installation by a qualified technician. If you want to change this start
up mode, call a qualified technician.
Stand by indication lamp :
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Standby mode.
VIDEO
green : operation
red : standby
PORT 1
OFF - ON
75 Ohm
PROJECTOR MODE
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation"
RS232 IN
RS232 OUT IR
REMOTE
RS232 INRS232 OUTIR
REMOTE