Filter
Top Products
Controlling
4-1
5975597 BARCODATA 808S 110397
4
CONTROLLING
Caution : Do not display a stationary image with full brightness
and contrast for longer than 20 min., otherwise you risk damage
to the CRT's.
Battery installation in the RCU.
A new battery (not yet installed to save the battery life) is delivered inside the plastic bag with the power
cord. Before using the RCU, follow the battery installation procedure.
Remove the battery cover on the backside of the RCU by pushing the indicated handle a little to the
bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type 6F22S or equivalent) in the lower compartment and connect the battery
to the contact plate.
Insert the battery into the lower compartment and put the cover back.
fig.1
310a.DRW
fig.2
Battery
Contact
plate
Behind the
plastic cover,
insert the 'card
for RCU'. You
can cut out the
correct insert
card on one of
the last pages of
this manual.