Filter
Top Products
DS72 Host Module
31
Network Interface
Logged Users
Unit Reset
IMPORTANT: Unit reset terminates both internal and external modem connections.
NOTE: You must be connected to the DS71-MD4 module to reset the unit. Resetting the unit
does not return user selections to their default settings.
Select “Reset Unit” followed by <cr>. The module resets the unit and displays:
Allow approximately 10 seconds for the unit to reset. It should state something similar to:
Troubleshooting:
Functional Solutions:
1. No menu serial port:
a. DS power is on and cable connected to EIA232 serial port.
b. Verify the cable and adapter has the correct pin out, RJ08X007 and 9FRJ45PC-1.
c. Cisco Rollover cables have the same pin out as RJ08X007.
System Status:
Available local memory (512 byte buffers): 16
TCP sockets in use:0
System up time (dd:hh:mm:ss):1:04:43:19
Available malloc memory: 32740
Strike CR to continue.
Network Status:
Medium status: fault
Medium faults: 0
Xmit bufr errs: 0
Available net buffers: 37
Receive queue status: open
Rev bufr errs: 1623
Strike ENTER to continue
Active Users:
User Address Internal Conn Status User Name
1 * RS-232 Port + admin
Strike "T", CR to terminate a session, CR to continue :
Reset the unit (Y/N) ?:y
Initializing System Please Wait ...........