Filter
Top Products
DS72 Host Module
9
Figure 2
Select option ‘8’ to add users with passwords and Enable/Disable access to the Network and Serial
ports. Select option ‘10’ to configure the Ethernet port
Login Setup
Figure 3
Header
This allows the admin to have enable or disable Header upon connection to the host module.
Access Control
This security feature allows the admin to enable or disable usernames and passwords for both serial
and modem port access.
Manage Users
This option allows the administrator to change user passwords or add/delete new users. Up to 19 users
plus an administrator allowed. Usernames are case sensitive and alphanumeric.
DS72 Data Switch Series - Telnet Host Module
Revision F.3.21.4 Kernel K.1.01H
Core C.1.00N Hardware H.2.01
Module 2
Status..........................1 Current status of DS72 module
Serial Port Configuration.......2 Change port config, 9600, 8, 1, none
Port Device Name................3 Change the name of the module port
Attention Character.............4 (;;;;;) get Main Menu
Disconnect Timeguard............5 Delay to see if more data after ‘;’
char
Connection Override.............6 User override another for priority
Connect Port ID Echo............7 Enable echo module & port#, device
name
Login Setup.....................8 Manage User, Port, Header
SNMP Configuration..............9 Trap Address, Read/Write,
Enable/Disable
Network Port Configuration......10 Ethernet configuration menu
Unit ID.........................11 Name of the module
Upgrade Firmware................12 FTP-Firmware upgrade w/user password
Active Restore..................13 Allow units to internally reset for
freezes, login idle timeouts,
RPC Management..................14 Set thresholds temp/v/c
Exit............................X,CR
Enter Request :1
Header..........................1 Enable/Disable Header for each menu
Access Control..................2 Enable/Disable Network/Serial port
user name and password
Manage Users....................3 Add/Delete users and change passwords
Exit............................X,CR