B&B Electronics RT12-0044-ZP-12 Mouse User Manual


 
Manual Documentation Number: RT-12 series-4006m 17
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
RT12-2222-ZP-S12 – External Battery Back-up
Connecting an Optional External Backup Battery to RT12-2222-ZP-S12
!WARNING!
Use Caution When Connecting Any Rechargeable Battery to any of the
RT series RTU’s. Make sure that the BATTERY is NOT connected until the
connection is made to the controller first. This will minimize the chance of damage to
the controller if the charging wiring harness is connected incorrectly. Use only Nickel
Cadmium 12Vdc and a minimum of 1.5 Amp Hour batteries. Use only fused cable.
The RTU is internally fused as well.
1) Connect the RED wire from the Charging wiring harness to pin 19, “BATT” of
the respective RTU device. The Master and Slave controllers are identical in
wiring, features and programming. Be sure a 1 Amp FAST blow fuse is installed.
2) Connect the BLACK wire from the Charging wiring harness to pin 20 ,“Gnd”, of
the respective RTU.
3) Confirm the above instructions. If the connections are correct, connect the RED
wire to the (+) of the battery and the black wire to the (-). The RTU will begin to
operate.
18 Manual Documentation Number: RT-12 series-4006m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
RT12-0044-ZP-S12 – Front Panel Identification
All analog voltage inputs and outputs are 12-bit, 0-5 Vdc. All digital inputs are
from 0 to 12 Vdc. Digital inputs must fall to 0Vdc as a LOW. Digital outputs are
Open Drain.
Connection Screw Terminal Description
PIN NAME DESCRIPTION
1 BATT (+) Battery I/O. 10.5~28 Vdc
2 GND (-) Battery
3 DO 4 Digital Output-4
4 PWR (+) Power Input. 10~28 Vdc
5 GND Ground
6 DI 4 Digital Input-4
7 DO 3 Digital Output-3
8 DO 2 Digital Output-2
9 DO 1 Digital Output-1
10 DI 3 Digital Input-3
11 DI 2 Digital Input-2
12 DI 1 Digital Input-1