Belkin F1D104-OSD Switch User Manual


 
Hardware Installation (continued)
6
1. Set the DIP switches. If you have only one OmniView
PRO, use the MASTER bank
setting. If the OmniView
PRO you are using will be daisy-chained off another unit, use a
unique slave setting. Please refer to the previous section for more information.
PLEASE FOLLOW THIS INSTALLATION PROCEDURE EXACTLY. NOT
DOING SO MAY RESULT IN KEYBOARD AND/OR MOUSE ERRORS, OR
FAULTY OPERATION.
WARNING: Before attempting to connect anything to the OmniView
PRO or the
computers, make sure everything is powered off. Plugging and unplugging cables may
cause irreversible damage to your computers and the OmniView
PRO. Belkin Components
will not be held responsible for damage caused.
BANK ADDRESS
2. Connect the monitor to the OmniView
PRO. Using the attached cable, or the one
included with your monitor, connect it to the HDDB15 female port on the back of the
OmniView
PRO labeled with the monitor symbol at the CONSOLE section.
Monitor
DIP SWITCH #
1234
ON ON ON ON
ON
ON ON OFF
BANK 0 MASTER
BANK 1 slave
BANK 2 slave
BANK 3 slave
ON ON ON OFF
ON ON OFF OFF
NOTE:"ON" is down
P72895_F1D104-OSD-univ_man.qxd 7/16/01 3:24 PM Page 6