Filter
Top Products
14
Usage (continued)
SCAN TIME:
Amount of time the OmniView
™
PRO stays on
one port before switching to the next port when
in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port Name
remains displayed on-screen after making a
port selection.
[↕]: SELECT
(INS): RENAME
(Enter): COMPLETE
(Esc): Exit
SCAN TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
DISPLAY TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on
the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKs (if their slave
units present) and then puts the unit in AutoScan mode. If the unit is a single MASTER
unit, pressing the button immediately invokes AutoScan mode. This is evident by a
long BEEP, followed by two short beeps.
P72895_F1D104-OSD-univ_man.qxd 7/16/01 3:24 PM Page 14