Belkin F1DP116SEA Server User Manual


  Open as PDF
of 68
 
13
section
Network Configuration
Assigning IP from the Console Port—VT-100 (Console, Telnet, SSH)
The Console Server also offers a user-friendly, menu-driven command-line interface. You
can simply connect a VT-100 terminal to the local console port to access the Console
Server. This is useful when you do not know the network settings of the Console Server, and
cannot access it. Through the local console port, you can view or change the settings (IP
address, subnet mask, etc.).
1. Connect the console port on the rear panel to a serial port on a PC host using
the CAT5 cable and the local console port RJ45/DB9F adapter, included with the
Belkin Console Server.
2. Configure a terminal emulation program, such as HyperTerminal, using the
following parameters:
• Baudrate=115200
• Databits=8
• Stopbits=1
• Parity=none
• Flowcontrol=none
Note:User names and passwords are the same as the ones set through the web interface.
The defaults are “admin/admin”.
 previous next