Filter
Top Products
Chapter 5 Installing Additional Memory
24
NOTE Use only HP DIMMs listed in HP Information Assistant or HP
Order Assistant.
Installing Additional Memory in the LH 4
1. Turn OFF the NetServer and remove all cables from the rear of the
NetServer. Pull both power plugs out.
2. Remove cover 3 and the bezel (see Chapter 3, "Removing and Replacing
Covers").
3. Loosen the memory cage screw, and swing the cover open (see Figure 5-
2).
Figure 5-2. Memory Cage
4. Unseat each memory board with the release clips, and remove the two
boards (see Figure 5-3).