Filter
Top Products
Chapter 10 Configuring the NetServer
67
it, select Configure Non-PnP board on the information window that
pops up.
• View Configuration Advisories: Read the configuration advisories, and
print them if necessary. You can change your hardware at this time to
conform to the advisories.
• Configure Remote Management: This utility configures the Integrated
Remote Management device for remote management. It enables remote,
dial-up server management. To configure Integrated Remote Assistant,
select Configure Remote Management on the Configure Remote
Management screen.
• Show System Information: Use this screen to display information about
standard and accessory boards and devices in the system, and the used and
available system resources.
◊ Select View System Information on the Show System Information
screen to display information about standard and accessory boards and
devices in the system.
◊
Select View Resources on the Show System Information screen to
display used and available system resources, such as memory ranges,
I/O port ranges, DMA channels, and interrupt (IRQ) levels.
• Install Utility Partition: This step creates an 8 MB utility partition on the
server hard disk where HP Navigator will copy DiagTools, the BIOS
update utility, the event log report utility, the disk array utility, the NIC
configuration utility, the Integrated Remote Assistant utilities,
troubleshooting utilities, and other utilities. It is not available for SCO
UNIX. Select Execute on the Install Utility Partition screen.
• Execute Board Utilities: When Configuration Assistant detects installed
boards for which there are additional configuration utilities on the HP
NetServer Navigator CD-ROM, you can execute these utilities to complete
the configuration of the boards by selecting Execute on the Execute Board
Utilities screen.
Custom Configuration
In Custom configuration mode, you perform the same configuration steps as for
Express configuration mode, but you can do them in any order. Select Custom on
the Configuration Assistant menu if you are experienced in NetServer