Filter
Top Products
Operation24
signal which is compatible with the projector's resolution or set the input signal to a lower
setting. See "Timing chart" on page 62 for details.
Adjusting the projected image
Adjusting the projected imageAdjusting the projected image
Adjusting the projected image
Adjusting the projection angle
Adjusting the projection angleAdjusting the projection angle
Adjusting the projection angle
The projector is equipped with 1 quick-release adjuster foot and 1 rear adjuster foot. These
adjusters change the image height and projection angle. To adjust the projector:
1. Press the quick-release button and lift the front
of the projector. Once the image is positioned
where you want it, release the quick-release
button to lock the foot in position.
2. Screw the rear adjuster foot to fine-tune the
horizontal angle.
To retract the foot, hold up the projector while
pressing the quick-release button, then slowly lower
the projector. Screw the rear adjuster foot in a reverse
direction.
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to each
other, the projected image becomes trapezoidal. To
correct this situation, see "Correcting keystone" on
page 28 for details.
Auto-adjusting the image
Auto-adjusting the imageAuto-adjusting the image
Auto-adjusting the image
In some cases, you may need to optimize the picture
quality. To do this, press AUTO
AUTOAUTO
AUTO on the projector or
remote control. Within 3 seconds, the built-in
Intelligent Auto Adjustment function will re-adjust the
values of Frequency and Clock to provide the best
picture quality.
The current source information will be displayed in the
corner of the screen for 3 seconds.
• The screen will be blank while AUTO is functioning.
• This function is only available when a PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
Fine-tuning the image size and clarityFine-tuning the image size and clarity
Fine-tuning the image size and clarity
1
2
Do not look into the lens while
the lamp is on. The strong light
from the lamp may cause
damage to your eyes.
Be careful when you press the
quick-release button as it is
close to the exhaust vent where
hot air comes from.
1. Adjust the projected image to the size
that you need using the zoom ring.
2. Sharpen the image by rotating the
focus ring.