Filter
Top Products
Operation40
Controlling the projector through a Lan
Controlling the projector through a Lan Controlling the projector through a Lan
Controlling the projector through a Lan
environment
environmentenvironment
environment
Lan Control Settings
Lan Control SettingsLan Control Settings
Lan Control Settings allow you to manage the projector from a computer using a web
browser when the computer and the projector are properly connected to the same local area
network.
Configuring the
Configuring the Configuring the
Configuring the Lan Control Settings
Lan Control SettingsLan Control Settings
Lan Control Settings
If you are in a DHCP environment:
If you are in a DHCP environment:If you are in a DHCP environment:
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
2. Press MENU/EXIT
MENU/EXITMENU/EXIT
MENU/EXIT and then press / until the SYSTEM SETUP: Advanced
SYSTEM SETUP: AdvancedSYSTEM SETUP: Advanced
SYSTEM SETUP: Advanced menu
is highlighted.
3. Press to highlight Lan Control Settings
Lan Control SettingsLan Control Settings
Lan Control Settings and press MODE/ENTER
MODE/ENTERMODE/ENTER
MODE/ENTER. The Lan Control
Lan Control Lan Control
Lan Control
Settings
SettingsSettings
Settings page displays.
4. Press to highlight Control By
Control ByControl By
Control By and press / to select RJ45
RJ45RJ45
RJ45.
5. Press to highlight DHCP
DHCPDHCP
DHCP and press / to select On
OnOn
On.
6. Press to highlight Apply
ApplyApply
Apply and press MODE/ENTER
MODE/ENTERMODE/ENTER
MODE/ENTER.
7. Re-enter the Lan Control Settings
Lan Control SettingsLan Control Settings
Lan Control Settings page. The Projector IP Address
Projector IP AddressProjector IP Address
Projector IP Address, Subnet Mask
Subnet MaskSubnet Mask
Subnet Mask,
Default Gateway
Default GatewayDefault Gateway
Default Gateway, and DNS Server
DNS ServerDNS Server
DNS Server settings will display. Note down the IP address
displayed in the Projector IP Address
Projector IP AddressProjector IP Address
Projector IP Address row.
If the Projector IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
If you are in a non-DHCP environment:If you are in a non-DHCP environment:
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press to highlight DHCP
DHCPDHCP
DHCP and press / to select Off
OffOff
Off.
3. Contact your ITS administrator for information on the Projector IP Address
Projector IP AddressProjector IP Address
Projector IP Address, Subnet
Subnet Subnet
Subnet
Mask
MaskMask
Mask, Default Gateway
Default GatewayDefault Gateway
Default Gateway, and DNS Server
DNS ServerDNS Server
DNS Server settings.
4. Press to select the item you want to modify and press Mode/Enter
Mode/EnterMode/Enter
Mode/Enter.
5. Press / to move the cursor and the press / to enter the value.
6. To save the settings, press Mode/Enter
Mode/EnterMode/Enter
Mode/Enter. If you do not want to save the settings, press
Menu/Exit
Menu/ExitMenu/Exit
Menu/Exit.
7. Press to highlight Apply
ApplyApply
Apply and press MODE/ENTER
MODE/ENTERMODE/ENTER
MODE/ENTER.