Filter
Top Products
Operation 47
Description of each menu
Description of each menuDescription of each menu
Description of each menu
Function
(Default setting/value)
Description
Wall Color
(Off)
Corrects the projected picture’s color when the projection surface is not
white. See "Using Wall Color" on page 32 for details.
Aspect Ratio
(Auto)
There are four options to set the image's aspect ratio depending on
your input signal source. See "Selecting the aspect ratio" on page 30 for
details.
Auto
Keystone
(On)
Automatically corrects any keystoning of the image. See "Correcting
keystone" on page 28 for details.
Keystone
(0)
Corrects any keystoning of the image. See "Correcting keystone" on
page 28 for details.
Position
(0)
Displays the position adjustment page. To move the projected image,
use the directional arrow keys. The values shown on the lower position
of the page change with every key press you made until they reach their
maximum or minimum.
This function is only available when a PC signal (analog RGB) is
selected.
Phase
(depends on the
selected input
signal)
Adjusts the clock phase to reduce image
distortion.
This function is only available when a PC
signal (analog RGB) is selected.
H. Size
(0)
Adjusts the horizontal width of the image.
This function is only available when a PC signal (analog RGB) is
selected.
Digital Zoom
(1.0X)
Magnifies or reduces the projected image. See "Magnifying and
searching for details" on page 30 for details.
Picture Mode
(Presentation)
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting a
picture mode" on page 32 for details.
Reference
Mode
(Dynamic)
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See "Setting the User 1/User 2 mode" on page 32 for
details.
Brightness
(50)
Adjusts the brightness of the image. See "Adjusting Brightness" on page
33 for details.
Contrast
(0)
Adjusts the degree of difference between dark and light in the image.
See "Adjusting Contrast" on page 33 for details.
1. DISPLAY menu
2. PICTURE menu