Filter
Top Products
Initial Setup
52 ETEP Installation Guide
the local time relative to UTC, add or subtract the offset hours from UTC for the local time zone (UTC ±
n). The following examples give the local time at various locations at 12:00 UTC when daylight saving
time is not in effect:
● New York City, United States: UTC-5; 07:00
● New Delhi, India: UTC+5:30; 17:30
To set the date and time:
1 At the command prompt, type
configure to enter configuration mode.
2At the
config> prompt, type date <year> <month> <day> <hour> <minutes>
<seconds>
3Type exit to return to the command prompt.
Example
admin> configure
config> date 2008 10 11 15 30 00
config> exit
Entering a Throughput License
The method for entering licenses on the ETEP depends on your management software:
● For ETEPs that are managed exclusively through the command line, follow the procedure in this
section.
● For EncrypTight deployments, throughput licenses must be managed with the EncrypTight software.
Licenses entered from the CLI are not recognized as valid in an EncrypTight deployment. See the
EncrypTight User Guide for more information.
Each ETEP is capable of transmitting traffic at a range of speeds that varies by model. When you install
the license you purchased, ETEPs transmit traffic at the speed specified by the license.Table 20 lists the
available speeds for each ETEP model.
year 2008-2037
month 01-12
day 01-31
hour 00-23
minutes 00-59
seconds 00-59
Table 20 ETEP Throughput Speeds
Model Available Throughput
ET0010A 3, 6, 10, 25, 50 Mbps
ET0100A 100, 155, 250 Mbps
ET1000A 500, 650 Mbps, 1 Gbps