Filter
Top Products
Diagnostic Code Display
ETEP Installation Guide 63
If the ETEP is discarding traffic, check the system log for temperature warning notices to confirm that a
temperature error occurred. Reboot the ETEP to resume normal operation.
Diagnostic Code Display
ETEPs display self-test codes during boot up, in addition to operational status and error conditions. See
the following sections for information about your appliance model:
● “Status Codes: ET0010A” on page 63
● “Diagnostic Codes: ET0100A and ET1000A” on page 64
Status Codes: ET0010A
The ET0010A status LEDs display self-test codes during boot up. After the ET0010A boots, the status
LEDs reflect the operational state of the appliance.
When the appliance powers up, the Alarm LED illuminates briefly and the four status LEDs illuminate to
verify that they are functioning. As the ET0010A cycles through its self-tests the status LEDs indicate the
self-test that is in progress (see Table 25). After the tests execute successfully, the status LEDs turn off.
If the ET0010A fails to boot properly the illuminated status LEDs indicate the number of the last test that
completed successfully, and a message describing the failure is displayed on the terminal. In addition, the
Alarm light illuminates if any of the first four self-tests fail (status LEDs 1, 2, 1&2, or 3). In the event of
a failure, make a note of the status code and of the error message on the console, and then contact Black
Box customer support.
After the ET0010A boots up
, the status LEDs reflect the operational state of the appliance.
.
Table 25 ET0010A Self-Tests
Status LEDs Illuminated Description
1, 2, 3, 4 LED display test.
1 Bootflash CRC test.
2 DRAM test #1.
1, 2 Initialize IO devices. DRAM test #2.
3 Initialize compact flash.
1,3 Complete bootloader initialization.
2,3 Download operating system.
1, 2, 3 Start operating system, IPSec dataplane code, and management
and control software.
All status LEDs off Up and operational.
Table 26 ET0010A Operational Codes
Code Description
All status LEDs off Up and operational.
2, 3, 4 The ET0010A is in a shutdown state.