Filter
Top Products
Black Box®LB1350A/LB1351A
29
TP port 1 basic control
:
========================
1. Change Auto-Negotiation
2. Change 10M/100M
3. Change duplex mode
4. Disconnect port
5. Connect port
6. Reset device
0. Back to port control menu
Select (0-6):
figure 6-7 – basic port control menu
Selecting any of these options will result in the appropriate action. The configuration
changes require about a second to take effect. When you change the port’s setup, it
will be restored the next time the device is powered on.
Please note that the port can only be disconnected when the VLAN mode is ‘enabled’.
Note that for the FO port the only two options will be the duplex mode change and the
device reset.
Advanced port control
The advanced port control menu, shown in figure 6-8, is composed of the following
options:
• Set tag insertion mode (enable/disable)
• Set tag stripping mode (enable/disable)
• Set the port’s VLAN ID (0-4095)
• Set port based priority mode (enable/disable)
• Set 802.1p based priority mode (enable/disable)
• Set TOS based priority mode (enable/disable)
• Set the port’s user priority (0-7)
TP port 1 advanced control
:
=============== ============
1. Enable/Disable tag insertion
2. Enable/Disable tag stripping
3. Set VLAN ID
4. Enable/Disable port priority
5. Enable/Disable 802.1p priority
6. Enable/Disable TOS priority
7. Set user priority
0. Back to port control menu
Select (0-7):
figure 6-8 – advanced port control menu
If you wish to change the port’s VID or its user priority, you will be prompted for the
desired values. Illegal values will not be accepted and will be rewarded with an ‘Invalid
value!’ error message.
Setting any of the other options will cause the device to prompt the user for enabling (1)
or disabling (0) the feature.
Please note that the VLAN related features (namely, tagging options) would take effect
when the VLAN mode is ‘enabled’.
Detailed information regarding these options can be found in the advanced status
section.