Filter
Top Products
Black Box®LB1350A/LB1351A
32
7.Managing with SNMP
When you wish to manage the Black Box® LB1351A with SNMP using a management
station, you should have the relevant MIB file (“bbLB1351A.mib”) installed and
compiled on any standard management application.
Once you have the appropriate network connection for managing the device you can
start getting the device parameters’ status and changing its settings.
Note that the meaning of each parameter is the same as its corresponding one in the
menus. You can therefore find the detailed explanations regarding these parameters in
the previous (terminal) section.
Note that viewing a parameter and setting its value is done in the same place in the
table (the method for setting might differ from one management application to another).
System info
Figure 7-1 shows the basic, MIB standard, system info table. It is accessible through
the standard’s MIB system info table.
figure 7-1 – system info
Basic device configuration
Basic device configuration table is located under
flLta31mDevice/flLta31mDeviceBasic in the device’s MIB sub-tree. The table is
shown in figure 7-2.
figure 7-2 – basic device configuration
Please note that the Test mode setting appears in this table, unlike the menus system
in which it appears under advanced device status/control.