Filter
Top Products
_______________________________________________________________________
34 Using Your Printer
The Self-Test may also be initiated while the power is on by simultaneously
pressing the PAUSE and CANCEL buttons. Simultaneously release them and
immediately press and hold the FEED button until the ribbon/media LED
flashes.
NOTE: If any configuration errors are indicated by the Self-Tests, check the
Printer's dip switch settings or configuration setup.
3.3.1 Test Label Examples
The first test label printed will be the Configuration Label, this label lists the
Printer's configuration and status. The following sample was produced on a
standard printer without the test plugs installed.
FRI SEPTEMBER 23, 1996 10:12 340
VER: GA - 1.14 01/30/96
ROM CHECKSUMS
U13 47-2091-01P
U24 47-2090-01P
U34 47-2088-01B
U2 47-2089-01B
SYSTEM RAM CHECKS_ _ _ _ GOOD SYSTEM RAM SIZE_ _ 512 KBYTES
SERIAL PORT BAUD RATE IS 9600 TRANSFER SWITCH IS ON
SWITCH 1 1 2 3 4 5 6 7 8
ON ON ON OFF OFF OFF OFF OFF
INTERNAL 1 2 3 4 5 6
OFF OFF OFF OFF OFF OFF
INPUT VALUES
PAPER: 255 EDGE: 253 REFL: 0 TEMP: 76
POT : 120 TOFA: 120 RIBN: 10 RWND: 0
COUNTER INFORMATION
ABSOLUTE VALUES 2-21-1996 RESETABLE VALUES 9- 5-1995
LENGTH_ _ _ _ 2317 INCHES LENGTH_ _ _ _ 2317 TIME_ _ _ _
_ _ 1 HOURS TIME_ _ _ _ _ _ 1 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE_ _ _ _ _ _ _ _ 15 SCALABLE FONTS_ _ _ _ _ _ _ _ 0
Figure 3-4 Configuration Test Label