Filter
Top Products
_____________________________________________________________________________________________________
60 Maintenance and Adjustments
5.3.3 Printhead Replacement
The Printhead is operator replaceable and can be replaced with a flat- bladed
screw driver. If dot patterns on the Configuration Test Label indicate lines of
missing dots, (as shown in Figure 5-4), the printhead is dirty or may require
replacement.
Figure 5-4 Configuration Test Label
A single missing dot, or two non-adjacent dots, does not indicate a bad
printhead; however, multiple adjacent missing dots do indicate a bad printhead.
Removal:
Follow the procedure below when replacing the printhead, (see
Figure 5-5).
1. Turn off the Printer and open the Side Access Cover.
2. Rotate the Printhead Latch downward to unlatch the Printhead, then raise
the Printhead to an upright position and lower the Hinge Plate.