Filter
Top Products
5
How to install the PowerGrid 902
Comtrend’s PG902 starter kit, supplied in pairs, comes ready to use;
the Powerline adapters are paired in our factory so they will recognize
each other, which makes setup this easy:
1. Plug both PG902 adapters into an electrical socket
a. One next your router (or modem)
b. One next to the device you will connect to your network
2. The Status LEDs on both PG902 adapters will light up RED
3. When the Status LEDs are both GREEN the adapters are ready
to use
Pick the PG902 adapter with a serial number ending with the letter “A”.
The serial number can be found on the label at the back of the adapter.
This is the Access Point (AP). Connect the AP to your router with an
Ethernet cable, as shown here.
Connect the other PG902 to your computer, V-box or other network
device using an Ethernet cable. This is the End Point (EP).
AP
/
S
T
B
Y
E
T
H
E
R
N
E
T
S
T
A
T
U
S
C
O
N
F
I
G
R
E
S
E
T
O
N
S
T
B
Y
P
o
w
e
r
l
i
n
e
E
t
h
e
r
n
e
t
A
d
a
p
t
e
r
w
i
t
h
F
i
l
t
e
r
LAN
1X
2X
3X
4X
Power
On
Off
LINE
A
P
/
S
T
B
Y
E
T
H
E
R
N
E
T
S
T
A
T
US
C
O
N
F
I
G
R
E
S
E
T
O
N
S
T
B
Y
P
o
w
e
r
l
i
n
e
E
t
h
e
r
n
e
t
A
d
a
p
t
e
r
w
i
t
h
F
i
l
t
e
r
260072-021_PG902_User_Guide(UK_A5 5 2008/8/6 �� 10:44:49