Filter
Top Products
7
How to add a new Powerline to your existing network
Comtrend Powerline pairs are paired in the factory for your convenience
and security. However if you need to add more adapters to your existing
network you will need to follow some easy steps in order to keep your
network secure. The following procedure applies to both Powerline
DH10PF and PG902 adapters.
MAKE SURE THAT ALL OF YOUR POWERLINES ARE CONNECTED
TO THE MAINS.
Step 1: Identify the current AP
(access point) adapter. From your
current adapters the one with the
AP LED in green will be the AP
adapter.
NOTE: If you performed a factory reset on the AP adapter (see step 2), it
is now an EP adapter. In this case, you will need to assign it as an
AP (see FAQ on pg. 8).
Step 2: Reset the new Adapter to its
factory settings: this is to make sure your
new adapter is set as an EP (end point).
Press the CONFIG/RESET button for 10
seconds. All LEDs will turn OFF and the
STATUS LED will be RED.
AP/STBY
ETHERNET
STATUS
CONFIG
RESET
ON
STBY
Powerline Ethernet
Adapter with Filter
AP/STBY
ETHERNET
STATUS
CONFIG
RESET
ON
STBY
Powerline Ethernet
Adapter with Filter
260072-021_PG902_User_Guide(UK_A7 7 2008/8/6 �� 10:44:49