Filter
Top Products
Brocade SMI Agent User’s Guide 45
53-1001778-01
CIMOM server configuration
3
FIGURE 28 Run XML dump
CIMOM server configuration
If the server is running on a system using multiple IP addresses, the server binds to an IP address
arbitrarily chosen by the underlying operating system. Using the following procedure, you can
configure the server to use a specific IP address.
Configuring the CIMOM server
1. Launch the Brocade SMI Agent Configuration Tool.
2. Click Server Configuration in the menu tree (see Figure 29 on page 46).
You must enable the stack before the SMI Agent can communicate using the IPv4 or IPv6
address.
3. Click Enable to enable the IPv4 stack, or click Disable to disable the IPv4 stack and use IPv6
instead.
4. Check the Bind to Address box to indicate the server should bind to a specific IP address, and
enter the IP address (in IPv4 or IPv6 format) in the field.
Clear the Bind to Address box to indicate that the server should bind to an IP address that is
arbitrarily chosen by the underlying operating system.
5. Click Apply.