Filter
Top Products
68
Out of Memory The machine’s memory is full. Copy operation in progress
Do one of the following:
Press Start to copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then
try again.
Clear the data from the memory. (See
Out of memory message on page 33.)
Print operation in process
Reduce print resolution. (See Advanced tab
in the Software User’s Guide on the CD-
ROM.)
Output Tray Full The ADF output tray has reached
its maximum capacity
Remove the scanned pages from the ADF
output tray. If you want to scan the remaining
pages of your documents press Start.
Print Unable XX The machine has a mechanical
problem.
Disconnect the machine from the power for
several minutes, then reconnect it.
Protected Device The protect switch of the USB
Flash memory drive is on.
Turn off the protect switch of the USB Flash
memory drive.
Rename the File There is already a file on the USB
Flash memory drive with the
same name as the file you are
trying to save.
Change the file name of the file on the USB
Flash memory drive or the file you are trying
to save.
Replace Drum The drum unit is the end of its life. Replace the drum unit with a new one.
(See Replacing the drum unit on page 88.)
The drum unit counter was not
reset when a new drum was
installed.
1 Open the front cover, and then press
Clear/Back.
2 Press 1 to reset.
Replace Fuser It is time to replace the fuser unit. Call your Brother dealer to replace the fuser
unit.
Replace Laser It is time to replace the laser unit. Call your Brother dealer to replace the laser
unit.
Replace PF Kit1 It is time to replace the paper
feeding kit for Tray 1.
Call your Brother dealer to replace the
PF Kit 1.
Replace PF KitMP It is time to replace the paper
feeding kit for the MP tray.
Call your Brother dealer to replace the
PF Kit MP.
Replace Toner The toner cartridge is at the end
of its life and printing is not
possible.
Replace the toner cartridge with a new one.
(See Replacing a toner cartridge
on page 85.)
Scan Unable XX The machine has a mechanical
problem.
Disconnect the machine from the power for
several minutes, then reconnect it.
Error Message Cause Action