Brother FAX 770 Fax Machine User Manual


 
126
CHAPTER FIFTEEN
PC Configuration Requirements
Your PC must meet or exceed the following minimum system configuration
requirements for you to install and use Multi-Function Link:
CPU 80486/66 or higher
RAM 8MB or greater for Windows
®
3.1 or 3.11
8MB or greater for Windows
®
95 (16MB recommended)
16MB or greater for Windows NT
®
Workstation
Version 4.0 (32MB recommended)
Hard Disk Drive 50MB
Operating System Windows
®
3.1, 3.11, 95 or NT
®
Workstation Version 4.0
Port Available Serial port
CD-ROM Drive
Connecting the MFC 970MC to Your PC
Follow the instructions below to hook up the Multi-Function Link Cable:
1
Position your Brother MFC near your personal computer CPU
(maximum distance of approximately 5–6 feet).
2
Make sure the power to the PC is switched off and the MFC is
unplugged.
3
Connect the RJ-8 connector of the Multi-Function Link Cable to the
back of your Brother MFC in the jack labeled PC I/F.
4
Connect the 25-pin male RS-232 connector of the Multi-Function Link
Cable to your PC in the available female serial communications port.
Use the 9-pin adapter if your PC requires it. (See your PC owner’s
manual for the correct interface port for connection.) NOTE: If your
PC is an IBM Aptiva, an MWAVE card is using COM1. You must
connect the Multi-Function Link Cable to another COM serial port
that is available.
or
or
PC I/F