Filter
Top Products
19
Windows
®
Wireless Network
Windows
®
Macintosh
Wireless Network
l If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to n.
m If your network is configured for Authentication
and Encryption, the following screen will
appear. When configuring your Brother
wireless printer, you must configure your
printer to match the Authentication and
Encryption settings you wrote down on
page 17 for your existing wireless network.
Choose the Authentication Method and
Encryption Mode from the pull-downs in each
setting box. Then enter the Network key and
Confirm Network Key, and then click Next.
n Click Next. The settings will be sent to your
printer. The settings will remain unchanged if
you click Cancel. The Network Configuration
page will be printed.
Note
• SETUP is the default SSID of the printer. Do
not choose this SSID.
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the printer and the access point are
within range for wireless communication. Then,
click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Add button. Follow the on-screen instructions
for entering the Name (SSID), and then click
Next.
Note
• If you want to setup or configure additional
WEP key indexes other than WEP key1, click
Advanced.
• If you do not know the Authentication or
Encryption settings for your network, contact
your network administrator or the manufacture
of your access point/router.
• If you are using WEP and the printed Network
Configuration page in n shows Link OK in the
Wireless Link Status, but the printer is not
found on your network, make sure you entered
the WEP key correctly. The WEP key is case
sensitive.
Note
• If you want to manually enter the IP Address
settings of your printer, click
Change IP Address and enter the necessary
IP Address settings for your network.
• The control panel settings will be automatically
changed to WLAN Enable when the wireless
settings are sent to your printer.