Filter
Top Products
109
CAN’T
HERE!
This message appears if the cursor is
at the end of the text when you hold
down c and press O.
Move the cursor below a
number before holding down
c and pressing O.
CASSETTE
CHANGED!
This message appears if the tape cas-
sette is changed while the P-touch is
receiving data from the computer.
Cancel the print job, install the
correct tape cassette, and then
try printing again.
CHANGE
ADAPTOR!
This message appears if a high-volt-
age adapter is being used.
Remove the high-voltage
adapter and connect the adapter
designed exclusively for this
machine.
CUTTER
ERROR!
This message appears if the tape cut-
ter is closed when you try to print or
feed the tape.
Turn the P-touch off, then on
again.
EEPROM
ERROR!
This message appears if a checksum
error occurred when the P-touch was
turned on or if the keyword was dam-
aged and failed to initialize.
Contact your service representa-
tive.
FEED
ERROR!
This message appears if the AV label
sensor cannot detect the labels.
• Replace the AV label cassette
with one that is not empty.
• If this error message appears
even after a new AV label cas-
sette is installed, the sensor
may be damaged. Contact
your service representative.
INPUT
WHOLE CODE
This message appears if the set
number of digits is not entered in the
barcode data.
Input the correct number of dig-
its or change the number of dig-
its set in the barcode parameters.
Error Message Cause Remedy