Filter
Top Products
TROUBLESHOOTING
58
Error Messages
Select Other
Margin! *
The tape length set using the tape length setting is shorter
than the total length of the left and right margins applied for
the "Large Margin" setting. Select a different margin setting.
Text
Too Long! *
The length of the label to be printed using the text entered is
longer than the length setting. Edit the text to fit within the set
length or change the length setting.
Text
Too High! *
The text size is too large. Select a different size option.
Check # of
Digits
Entered! *
The number of digits entered in the bar code data does not
match the number of digits set in the bar code parameters.
Enter the correct number of digits.
Input A,B,C or D
At Start&End! *
The bar code data entered does not have the required start/
stop code (A, B, C, or D required at the beginning and end of
the bar code data for the CODABAR protocol). Enter the bar
code data correctly.
Maximum Of
5 Bar Codes
Per Label! *
There are already 5 bar codes entered in the text data when
you try to enter a new bar code. You can only use up to five
bar codes in each label.
Category Full! *
The memory available for categories is full. To make more
memory available, delete any unnecessary registered label
files by highlighting the label file and pressing the
OK
key.
Installed tape is
not compatible with
this machine! *
Tape that is incompatible with the machine has been
installed. Use compatible tape.
OK to Feed? *
Feeding tape after printing when [Chain print]
is selected. Refer to ”Setting Margin” on page 45.
Message Cause/Remedy
*Press any key to clear the error message.