Filter
Top Products
INTRODUCTION
11
General Precautions
Rechargeable Li-ion battery
• At the time of purchase, the rechargeable Li-ion battery is slightly charged so that the
operation of the labeling system can be verified; however, the rechargeable Li-ion battery
should be fully charged with the AC adapter before the labeling system is used.
• If the labeling system will not be used for a long period of time, remove the rechargeable
Li-ion battery from the labeling system, and then store it in a location where it is not
exposed to static electricity, high humidity, or high temperatures (temperatures between
59°F/15°C and 77°F/25°C and 40% to 60% humidity are recommended). In order to
maintain the efficiency and life of the Li-ion rechargeable battery, charge it at least every
six months.
• If you notice anything unusual about the rechargeable Li-ion battery the first time it is used,
for example overheating or rust, DO NOT continue to use the battery. Contact Brother
customer service.
Labeling System
• DO NOT install the P-touch labeling system near any device that will cause
electromagnetic interference. The P-touch labeling system may malfunction if left near a
television or radio etc.
• DO NOT use the P-touch labeling system in any way or for any purpose not described in
this guide. Doing so may result in injury or damage to the labeling system.
• DO NOT put any foreign objects into the tape exit slot, AC adapter connector, or any other
part of the labeling system.
• DO NOT touch the print head (see page 6) with your fingers. Use the optional print head
cleaning cassette (TZe-CL4), the self-cleaning function of the labeling system, or a soft
wipe (e.g.a cotton swab) when cleaning the print head (see “Cleaning the Unit” on
page 46).
• DO NOT clean any part of the labeling system with alcohol or other organic solvents. Only
use a soft, dry cloth.
• DO NOT place the P-touch labeling system in direct sunlight, near heaters or other hot
appliances, or in any location exposed to extremely high or low temperatures, high
humidity, or dust. The standard operating temperature range of the P-touch labeling
system is 50
°F to 95°F.
• DO NOT leave any rubber or vinyl, or products made of rubber or vinyl, on the labeling
system for an extended period of time, otherwise the labeling system may become stained.
• Depending on the environmental conditions and the applied settings, some characters or
symbols may be difficult to read.
• Use only Brother TZe or HGe tapes with the P-touch labeling system. Do not use tapes
that do not have the / mark.
• DO NOT pull or apply pressure to the tape in the cassette to avoid damaging the P-touch
labeling system.
• DO NOT try to print labels using an empty tape cassette or without a tape cassette in the
P-touch labeling system. Doing so will damage the print head.
• DO NOT attempt to cut the tape while printing or feeding since this will damage the tape.
• Depending on the location, material, and environmental conditions, the label may unpeel
or become irremovable, and the color of the label may change or be transferred to other
objects.
General Precautions