Filter
Top Products
Specifying Common Settings
4-54
4
Customizing Settings
Job Duration Display
If the Job Duration Display mode is set to 'On', the remaining time that it takes to
complete an operation is displayed in minutes on the touch panel display.
NOTE
•
The wait time is displayed as <Approx Prt Time> (approximate printing time) on the
screen that is displayed when the machine is printing.
•
Even if Job Duration Display is set to 'On', the wait time is not displayed if the wait time is
less than one minute.
1
Press (Additional Functions) ➞ [Common Settings] ➞ [Job
Duration Display].
2
Select [On] or [Off] for each function ➞ press [OK].
Setting an Output Tray to Hold Different Paper Sizes
This mode enables you to output different paper sizes to the same output tray.
IMPORTANT
This mode is available only if an optional finisher is attached.
1
Press (Additional Functions) ➞ [Common Settings] ➞
[Different Paper Sizes for the Output Tray].
2
Select [On] or [Off] ➞ press [OK].
If Different Paper Sizes for the Output Tray is set to 'Off', and the message
<Remove the paper from the output tray.> is displayed, printing stops. Remove
all of the paper from the output tray, and printing resumes.
If both the Different Size Originals and Staple modes are set, outputs are stapled
and collated, regardless of the Different Paper Sizes settings.