Filter
Top Products
Service Call Message
8-102
8
Troubleshooting
Setting the Limited Functions Mode from the Service Call
Message Screen
If the Service Call Message screen appears indicating a malfunction of a Finisher
mode, you can clear it by turning the Limited Functions Mode 'On' to temporarily
limit the use of the finishing modes. However, after the Limited Functions Mode is
deactivated, the Service Call Message screen may appear again, unless the cause
of the malfunction is removed.
IMPORTANT
If you turn OFF the main power switch when there is a job waiting to print, that job is
erased.
NOTE
If you set Limited Functions Mode to 'On' from the Service Call Message screen, Limited
Functions Mode in Common Settings (from the Additional Functions screen) is also set to
'On'. (See "Limiting Functions," on p. 4-55.)
1
Press [Limited Fnctns Mode].