Filter
Top Products
AXIS 1610 User’s Manual Section 3: Installation
15
Section 3 Installation
Connecting a printer to the Network
Follow the instructions below to connect a printer to the
network via the AXIS 1610 print server.
Caution!
❏ Make sure that the AXIS 1610 external power supply you are
using is marked with the correct voltage!
1. Switch off the printer and disconnect the AXIS 1610 external
power supply.
2. Locate the serial number, found on the underside label of the
AXIS 1610, and write it down. You will need this number later
during the network configuration.
3. Connect the AXIS 1610 directly to the printer’s parallel printer
port.
4. Connect your AXIS 1610 to the network using a twisted pair
cable, category 5 or better.
5. Switch on the printer and connect the external power supply to
the AXIS 1610. The power indicator lights up. When the network
indicator starts to flash, the AXIS 1610 is successfully connected
to the network.
To establish communication with the TCP/IP network and the
internal web pages, an IP address must be assigned to your AXIS
1610.
If there is a DHCP server on your network, your AXIS 1610 will
already have received an IP address.
If not, refer to the table below for an appropriate method to set
the IP address of your AXIS 1610.