Filter
Top Products
13
7) Tube set up (IP Series Only)
a) Remove the backing to the double sided tape and attach the metal tube
support arm approximately 6cm from the front as pictured below.
Please be careful not to twist the tubing before connecting it to the printer.
b) Adjustments to the tube length may be required. To check this, move the
cartridge holder left and right to each end of the printer. It should reach both
ends with ease. Check that the tubing is neither too long nor too short. The
tubing must not interfere with the printer data wire nor should it fall down into
the paper support or cause any interference to the head movement.
c) If required, adjust the tube length by gently pulling the silicone tubing in the
direction required. DON’T HAVE THE TUBING FITTED TOO TIGHTLY.
X
6cm